The Thermal Grizzly PhaseSheet PTM Pro is a high-performance thermal pad designed for processors and graphics chips. The advanced phase change material (PCM) offers improved thermal conductivity compared to the original PhaseSheet PTM. Thanks to an optimised material composition and new carrier films, it combines efficient heat transfer with straightforward application.
- PCM technology: Adapts warmly to contact surfaces
- Pro formula: Enhanced heat transfer
- Reduced pump-out: Long-term consistent contact
- New carrier films: Easy peeling without tearing
- Non-conductive: Greater safety during installation
Optimised phase change material for efficient heat conduction
The PhaseSheet PTM Pro is based on a specialised phase change material that remains solid at room temperature, making it easy to apply. From approximately 45 °C, it begins to liquefy and conforms to the surfaces of the processor, graphics chip, and cooler. This compensates for microscopic unevenness and improves heat transfer between the contact surfaces.
Compared to the original PhaseSheet PTM, the Pro version offers higher thermal conductivity due to its optimised material composition. Its low initial thickness of 0.2 mm supports the formation of a thin contact layer and shortens the heat transfer path. The material develops and stabilises its maximum thermal conductivity after about ten heat cycles above 60 °C.
Reduced pump-out effect for long-lasting cooling performance
Repeated heating and cooling can cause the contact surfaces between chip and cooler to expand differently. With conventional thermal paste, this can lead to the so-called pump-out effect, where the paste is gradually pushed out of the contact area. The PhaseSheet PTM Pro has particularly low viscosity in its liquefied state and contracts again upon cooling.
This material change reduces the pump-out effect and supports consistently even heat transfer over the long term. This makes the thermal pad especially suitable for systems where permanently stable cooling performance and longer maintenance intervals are desired. Typical applications include servicing older graphics cards, replacing conventional thermal paste, and converting to water cooling.
Easy installation thanks to improved carrier films
The 40 x 40 mm thermal contact area can be placed between a processor or graphics chip and a compatible cooler. Due to the new material composition and the double-sided, easily removable carrier films, handling is significantly easier compared to the original PhaseSheet PTM. This reduces the risk of damaging the sensitive sheet when removing the films.
The material is electrically non-conductive, making it suitable for applications with exposed components near the contact surface. For optimal distribution, Thermal Grizzly recommends a contact pressure of approximately 300 to 400 N, while observing the installation guidelines of the respective hardware and cooler manufacturers. With an operating temperature range of -40 to +125 °C, the PhaseSheet PTM Pro offers a versatile thermal solution for high-performance CPU and GPU cooling systems.
|
Colour
|
|
|
Primary Colour
|
Grey
|
|
Dimensions
|
|
|
Length / Depth
|
40 mm
|
|
Width
|
40 mm
|
|
Height
|
0.2 mm
|
|
Contents
|
|
|
Weight (Contents)
|
0.82 g
|
|
Thermal Specifications
|
|
|
Min. Operating Temperature
|
-40 °C
|
|
Max. Operating Temperature
|
125 °C
|
|
Density
|
2.6 g/cm³
|
|
Compatibility
|
|
|
Compatibility Note
|
Please refer to the manufacturer's compatibility information. You can find the latest overview on the manufacturer's website.
|
|
Materials
|
|
|
Materials
|
Phase Change Material (PCM)
|
|
Electrically Conductive
|
No
|
Product reviews displayed are aggregated from all Pro Gamers Group websites.