Thermal Grizzly WireView Pro II GPU Monitoring Device - White, Reserved

The WireView Pro II has been specifically designed for the demanding use of modern high-end graphics cards with 12V-2x6 connectors and represents the advanced version of the WireView Pro. As a patented development by Thermal Grizzly, it is protected by the European patent EP4250057. The current is measured not only as a total value but per conductor of the 12V-2x6 connector. This allows potential contact issues between cable and graphics card to be identified immediately. The WireView Pro II was developed specifically to enable precise monitoring of the 12V-2x6 connector, allowing early detection of load distribution problems and helping to prevent possible damage to the graphics card and the 12V-2x6 connector.

Monitoring

All safety-relevant parameters such as currents (A), voltages (V), temperatures (°C), and power consumption (W) are continuously measured. Thermal Grizzly defines limit values that should not be exceeded during normal operation, as otherwise there is an increased risk of thermal damage to the connector. When these limits are exceeded, a visual warning is displayed on the screen along with an audible alarm. Optionally, automatic system shutdown is possible via the supplied splitter cable. The preset limit values can be changed through the configuration menu.

Cooling

Due to unavoidable contact resistances at connector joints, additional waste heat is generated during the operation of high-performance GPUs. For controlled heat dissipation, a semi-passive fan is integrated, which operates silently at idle and is automatically activated as power consumption or temperature rises. The CNC-milled aluminium housing features ventilation openings and serves as an active heat sink. An optimised airflow is supported by openings in the rear circuit board, guiding air along all heat-relevant components.

User-Friendliness

The WireView Pro II is available in two connector orientations and can therefore be used with almost any graphics card with a 12V-2x6 connector. The downward-facing connector orientation enables neat cable management, and the device simultaneously acts as a 90° adapter. Multiple views are available on the integrated TFT IPS display, which can be configured directly on the device. The device can be used entirely as a hardware solution and is additionally complemented by software (WireView2-SW-1.0.3). This is available in the product’s download section.

Automatic Data Collection

An integrated memory regularly logs relevant operating data to trace possible fault events. Recorded data include the 12-volt currents measured per pin, total power consumption, and temperature at the 12V-2x6 output (T-Out) near the connector. A data set is saved every 60 seconds. The memory allows for about 340 days of full load or around 3-4 years of typical operation before older entries are automatically overwritten. The collected data support both fault analysis and the further development of safer connector solutions within the community.